NXP USA Inc.
NXP Semiconductors, a frontrunner in embedded controllers, offers a wide array of MCUs with Arm-based processors. Their innovation extends to robust Power Management for industry and automotive use. NXP's products globally empower and interconnect, fostering proficiency for individuals, organizations, and the world. Noteworthy is the integration of Freescale Semiconductor into NXP (December 2015).
View All Product from NXP USA Inc. Bidirectional buffer isolates capacitance and allows 400 pF on port B of the device Voltage level translation from port A (1.35 V to VCC(B) 1.0 V) to port B (3.0 V to 5.5 V) Requires no external pull-up resistors on lower voltage port A Active HIGH repeater enable input Open-drain inputs/outputs Lock-up free operation Supports arbitration and clock stretching across the repeater Accommodates Standard-mode and Fast-mode I2C-bus devices and multiple masters
The PCA9509 is a level translating I2C-bus/SMBus repeater that enables processor lowvoltage 2-wire serial bus to interface with standard I2C-bus or SMBus I/O. While retainingall the operating modes and features of the I2C-bus system during the level shifts, it alsopermits extension of the I2C-bus by providing bidirectional buffering for both the data(SDA) and the clock (SCL) lines, thus enabling the I2C-bus or SMBus maximumcapacitance of 400 pF on the higher voltage side. Port A allows a voltage range from1.35 V to VCC(B) 1.0 V and requires no external pull-up resistors due to the internalcurrent source. Port B allows a voltage range from 3.0 V to 5.5 V and is overvoltagetolerant. Both port A and port B SDA and SCL pins are high-impedance when thePCA9509 is unpowered.For applications where Port A VCC(A) is less than 1.35 V or Port B VCC(B) is less than 3.0 V,use drop-in replacement PCA9509A.The bus port B drivers are compliant with SMBus I/O levels, while port A uses a currentsensing mechanism to detect the input or output LOW signal which prevents bus lock-up.Port A uses a 1 mA current source for pull-up and a 200 pull-down driver. This results ina LOW on the port A accommodating smaller voltage swings. The output pull-down on theport A internal buffer LOW is set for approximately 0.2 V, while the input threshold of theinternal buffer is set about 50 mV lower than that of the output voltage LOW. When theport A I/O is driven LOW internally, the LOW is not recognized as a LOW by the input.This prevents a lock-up condition from occurring. The output pull-down on the port Bdrives a hard LOW and the input level is set at 0.3 of SMBus or I2C-bus voltage levelwhich enables port B to connect to any other I2C-bus devices or buffer.The PCA9509 drivers are not enabled unless VCC(A) is above 0.8 V and VCC(B) is above2.5 V. The enable (EN) pin can also be used to turn on and turn off the drivers undersystem control. Caution should be observed to change only the state of the EN pin whenthe bus is idle.
TYPE | DESCRIPTION | Select all |
---|---|---|
Applications | - | |
Mounting Type | - | |
Type | - | |
Operating Temperature | - | |
Product Status | Active | |
Current - Supply | - | |
Package | Bulk | |
Voltage - Supply | - | |
Series | * | |
Capacitance - Input | - | |
Signal Conditioning | - | |
Delay Time | - | |
Number of Channels | - | |
Data Rate (Max) | - | |
Output | - | |
Supplier Device Package | - | |
Input | - | |
Package / Case | - |
NXP USA Inc.
NXP Semiconductors, a frontrunner in embedded controllers, offers a wide array of MCUs with Arm-based processors. Their innovation extends to robust Power Management for industry and automotive use. NXP's products globally empower and interconnect, fostering proficiency for individuals, organizations, and the world. Noteworthy is the integration of Freescale Semiconductor into NXP (December 2015).
View All Product from NXP USA Inc.IC REDRIVER I2C 2CH 400KHZ 8SOIC
IC REDRIVER I2C 1CH 1MHZ 8HWSON
IC REDRIVER I2C 1CH 8TSSOP
IC REDRIVER I2C 2CH 8TSSOP
IC REDRIVER I2C 1CH 400KHZ 8SO
IC REDRIVER I2C 5CH 16TSSOP
IC ACCELERATR I2C HOTSWAP 8TSSOP
IC REDRIVER I2C 2CH 10TSSOP
IC REDRIVER I2C 2CH 400KHZ 8SO
IC REDRIVER I2C 3CH 16TSSOP